Corresponding Author:
Sejal k. Patel
S. K. Patel college of Pharmaceutical Education and Research, Ganpat University, Kherava-382 711, India
E-mail: skpatel_2@rediffmail.com
Date of Submission 22 August 2007
Date of Revision 13 June 2008
Date of Acceptance 20 December 2008
Indian J. Pharm. Sci., 2008, 70 (6): 825-827  

Abstract

Simple, specific, accurate and precise method, namely, reverse phase high performance liquid chromatography was developed for estimation of duloxetine HCl in pharmaceutical formulations. For the high performance liquid chromatography method, Phenomenox C-18, 5 µm column consisting of 250×4.6 mm i.d. in isocratic mode, with mobile phase containing 0.01M 5.5 pH phosphate buffer: acetonitrile (60:40 v/v) and final pH adjust to 5.5±0.02 with phosphoric acid was used. The flow rate was 1.2 ml/min and effluent was monitored at 231 nm. The retention time was 5.61 min. The method was validated in terms of linearity, accuracy and precision. The linearity curve was found to be linear over 0.25-4 µg/ml. The limit of detection and limit of quantification were found to be 0.10 and 0.25 µg/ml respectively. The proposed method was successfully used to determine the drug content of marketed formulations.

Keywords

Duloxetine HCl, isocratic mode, RP-HPLC, SSNRI.

Duloxetine HCl (DLX) is chemically, 2(+)-(S)- N - m e t h y l - ( g a m m a ) - ( 1 - n a p h t h y l o x y ) - 2 thiophenepropylamine hydrochloride [1]. Duloxetine hydrochloride is a newer selective serotonin and norepinephrine reuptake inhibitor (SSNRI) used for major depressive disorders [2,3]. Duloxetine is not official in any pharmacopoeia. A few methods in literature were reported for the determination of DLX and its key intermediate, desmethyl duloxetine in human serum by HPLC method [4-5]. Literature reported the characterization of phenolic impurities in duloxetine HCl samples by MS, NMR, X-rayanalysis [6] and impurities formed by interaction of duloxetine HCl with various enteric polymers [7]. Simple UV Spectrophotometric method for estimation of duloxetine in formulation [8] is reported but calibration range is from 5-50 µg/ml that shows the method is less sensitive. The present investigation describes a simple, rapid and reproducible RP-HPLC method with a calibration range of 0.25-4 µg/ml for duloxetine HCl in capsule dosage form that is more appropriate for routine analysis.

A Shimadzu’s HPLC (LC-10AT vp) equipped with UV/Vis detector and manual injector of 20 μl loop, CP224S analytical balance (Sartorius), Ultrasonic bath (Frontline ultrasonic) were used for experiment. Volumetric flasks of 5, 10, and 50 ml capacity and other glassware (Borosil) were used.

Duloxetine hydrochloride (Torrent Pharmaceuticals Ltd. Ahmedabad, India), acetonitrile, methanol (HPLC grade, S. D. Fine Chemicals), triple distilled water, nylon 0.45 μm-47 mm membrane filter (Gelman laboratory, Mumbai, India), potassium dihydrogenphosphate, disodium hydrogen phosphate and phosphoric acid (AR grade, S. D. Fine Chemicals) were used for the study.

The standard stock solution of duloxetine HCl was prepared by dissolving 5 mg of drug in 50 ml volumetric flask separately using methanol. Final working standard solution of 25 μg/ml of duloxetine HCl was prepared by diluting 2.5 ml of the above solution to 10 ml with methanol. 0.25, 0.50, 0.75, 1.0, 2.0, 3.0 and 4.0 µg/ml concentration of solutions were prepared and injected under operating chromatographic conditions. Calibration curves were constructed by plotting peak area versus concentration of duloxetine HCl and the regression equation were calculated.

Assay of three different marketed products were performed. Twenty capsules were separately weighed and a quantity of mixed contents of 20 capsules equivalent to 5 mg of duloxetine hydrochloride was dissolved in methanol to obtain 1 mg/ml concentration, ultrasonicated and filtered through 0.45 mm cellulose nitrate filter. The solution was subjected to analysis as described earlier after suitable dilution. From the peak area of duloxetine HCl the amount of drug in the sample was computed using regression equation.

Parameters Result
Linearity range 0.25-4 µg/ml
Correlation co-efficient 0.9994
Retention time 5.61 min.
Tailing factor 1.30
Asymmetry 1.44
Precision (% CV)  
Repeatability 0.512%
Intra day 0.37-1.16%
Inter day 1.13-1.94%
Accuracy 97.8-100.5%
Limit of detection 0.10 µg/ml
Limit of quantification 0.25 µg/ml

Table 1: Parameters Of Chromatogram

Conc. of duloxetine % CV % CV
hydrochloride (µg/ml) (Intra day) (Interday)
0.25 1.16 1.94
0.50 0.58 1.22
0.75 0.60 1.13
1.0 0.54 1.16
2.0 0.40 1.15
3.0 0.37 1.21
4.0 0.38 1.16

Table 2: Intraday And Interday Precision Data For Duloxetine Hydrochloride At 231nm

To optimize the HPLC parameters, several mobile phase compositions were tried. Satisfactory peak symmetry was obtained with mobile phase consisting of phosphate buffer (5.5 pH):acetonitrile (60:40 v/v) and final pH adjusted to 5.5±0.02 with phosphoric acid. Quantification was achieved with UV detection at 231 nm based on peak area. A representative chromatogram is shown in fig. 1. Parameters of chromatogram are shown in Table 1.

The regression data showed a good linear relationship over a concentration range of 0.25-4 µg/ml. The limit of detection and limit of quantification were found to be 0.10 and 0.25 µg/ml, respectively. As per the USP XXIII [9], system suitability tests for HPLC were carried out on freshly prepared standard stock solution of duloxetine HCl and parameter obtained with 20 µl injection volume are summarized in Table 1. The intra-day and inter-day precision was determined by analyzing standard solutions in the concentration range of 0.25 to 4 µg/ml. The intra-day and inter-day precision results are given in Table 2. The results of the analysis of marketed formulations are well agreed with the label claim (Table 3). To study accuracy of the developed methods, recovery studies were carried out using standard addition method at four different levels for all the three brands and the % recovery was calculated (Table 4). The results revealed no interference from the excipients. The developed methods are simple, precise and accurate. The statistical data proved that methods are reproducible and selective for the analysis of duloxetine HCl in its marketed formulations.

Formulation Labeled amount of duloxetine hydrochloride (mg) % Duloxetine hydrochloride found (n=3)
A 20 101.2±0.2
B 30 98.58±0.1
C 40 99.41±0.4

Table 3: Estimation of duloxetine .Hydrochloride in capsules.

Formulation Initial conc. Quantity of std. Total quantity Accuracy
  (µg/ml) added (µg/ml) found Mean±SD ±% CV
A 0.5 0.5 0.978±0.028 97.8±1.86
  0.5 1.5 1.976±0.034 98.8±1.72
  0.5 2.5 3.015±0.048 100.5±1.59
  0.5 3.5 3.971±0.067 99.27±1.68
B 0.5 0.5 0.998±0.031 99.8±1.63
  0.5 1.5 1.959±0.032 97.95±1.74
  0.5 2.5 2.999±0.043 99.96±1.45
  0.5 3.5 4.012±0.053 100.3±1.63
C 0.5 0.5 1.002±0.025 100.2±1.24
  0.5 1.5 2.003±0.039 100.15±1.55
  0.5 2.5 3.021±0.052 100.7±1.79
  0.5 3.5 4.015±0.074 100.37±1.44

Table 4: Accuracy Data For Duloxetine Hydrochloride At 231nm.

Acknowledgements

The authors thank Torrent Pharmaceuticals Ltd., Ahmedabad for providing gift sample of duloxetine HCl. The authors are thankful to S. K. Patel College of Pharmaceutical Education and Research, Ganpat University, Kherva, Mehsana for providing facilities to carry out the work.

References